Beverley Short Lamp Shades November 05th, 2018 - 15:08:09
Pendant light fixture you'll receive a glass stone. The fixture, a spacer ring hanging bulb socket a pack of hardware and installation instructions. The spacer ring will sit, atop, the glass dome and the light socket has a large plastic nut that was secured to the socket from the underside of the glass feed the socket through the spacer and into the dome then tighten the ring. On the other side, the small thumb screws on the spacer are for show only and do not actually hold anything the ceiling plate on top measures, five and three-quarter inches in diameter to open it, remove the two thumb screw caps on the underside then take out the mounting plate, there's a copper ground wire that will attach to the green ground post and the black and white wires are hot and neutral respectively.
Here is the light fixture that I will be replacing it's a metal dome with a frosted orb diffuse. The light from this fixture isn't very bright. After shutting off the power at the breaker I disassembled the fixture by removing the diffuse and the bulb, then I removed the hanging chain and ceiling plate. The mounting plate of the new fixture should screw into the existing junction box, used included hardware to install it and pull the wiring for the light fixture through the middle. Here you can see. I have the red hot water and a few neutrals connected together at this Junction. I've also attached the ground wires to the ground post already.
Then I used two yellow wire connectors to connect the fixtures positive lead to the hot wire and the neutral lead to the neutral wires and ran the ground wire up to the ground post. Once it's assembled, tighten the thumbscrew caps to secure the ceiling plate over the junction box and hole. If you loosen the small screw on the side where the cable comes out, you can feed some of the wire into the ceiling cap to shorten its length and raised a light fixture higher the longest lengths is about four feet. So here's the fixture installed with a standard LED light bulb because the fixture is clear.